Absolutely hated my louvre bifold but space is limited and not other options for two bedroom closets ! I found these on and thought I would try them out . Picked up unfinished solid wood bifolds from lowes and had my contractor stain and then install on this track which is genius ! They match my sliding barn doors and look so great ! So happy !
We installed over wood panels so it wouldnt smash the drywall. There are no words in the instructions/ only diagrams. But it was easy enough to figure out what went where. Only issue was finding a 15mm drill bit for the stopper on the bottom of the doors.
Basics instructions fyi
Best with 3 people.
Had to furr out the closet opening because our bifold doors were meant to go inside the opening instead of outside and thus smaller.
Mark center of top sliding bar.
Hold bar up and drill the 5 holes into wood stud. Attach the bar.
Attach 4 plates at the tops of the sliding doors.
Drill 2 holes for stoppers in bottom of doors at edges. Temporarily tape the stopper to bottom of doors.
Put the doors on the track via the 4 rollers. Do not fasten. But be careful because they could fall off.
Align doors as desired.
Remove tape from stopper and mark where it hits the floor. Remove doors.
Fasten stoppers to floor via 4 screws each.
Put doors back up and tighten with Allen wrench.
It took me some times to get it together but, I finally got it done all alone. Im a 38yrs old female , I dont have a license to do this time of work but Always enjoy doing this type of project and of course save tons of money I just ordered the 2nd hardware kit and I know it will be a piece of cake to put up the next one together. I will post more pics up for the next one.
This barn track is really nice and sturdy for sure. However, the instructions are not good. They use measurements of mm instead of inches and there are no words whatsoever only pictures. I am very handy have put 3 other barn doors up but this guy gave me a run for my money. The lower pivot has to go into the floor and not the wall or casing like your standard bi fold door. In my case I had to drill through porcelain tile as I used the door in my bathroom. Now that its installed I love it.
I didnt know this sort of barn door hardware existed for bi/fold doors until I happened upon it in . Wed been looking for a modern solution to adding doors to our non/standard closet opening and this worked perfectly. It mounts easily and holds the doors well. Id recommend it for anyone looking to mount bi/fold doors without having a clunky floor track.
Reviews
Was expecting to look a bit more rustic
Very pretty
Great seller!
We used these doors for a closet in a small barn apartment. The finish is great and they look good. Would buy from this seller again!
Works as it should!
We used it over an arched door. It works perfectly, an affordable solution over a custom door.
Looks aming
Absolutely hated my louvre bifold but space is limited and not other options for two bedroom closets ! I found these on and thought I would try them out . Picked up unfinished solid wood bifolds from lowes and had my contractor stain and then install on this track which is genius ! They match my sliding barn doors and look so great ! So happy !
Looks great
We installed over wood panels so it wouldnt smash the drywall. There are no words in the instructions/ only diagrams. But it was easy enough to figure out what went where. Only issue was finding a 15mm drill bit for the stopper on the bottom of the doors. Basics instructions fyi Best with 3 people. Had to furr out the closet opening because our bifold doors were meant to go inside the opening instead of outside and thus smaller. Mark center of top sliding bar. Hold bar up and drill the 5 holes into wood stud. Attach the bar. Attach 4 plates at the tops of the sliding doors. Drill 2 holes for stoppers in bottom of doors at edges. Temporarily tape the stopper to bottom of doors. Put the doors on the track via the 4 rollers. Do not fasten. But be careful because they could fall off. Align doors as desired. Remove tape from stopper and mark where it hits the floor. Remove doors. Fasten stoppers to floor via 4 screws each. Put doors back up and tighten with Allen wrench.
Very pleased .
It took me some times to get it together but, I finally got it done all alone. Im a 38yrs old female , I dont have a license to do this time of work but Always enjoy doing this type of project and of course save tons of money I just ordered the 2nd hardware kit and I know it will be a piece of cake to put up the next one together. I will post more pics up for the next one.
Nice but instructions are terrible
This barn track is really nice and sturdy for sure. However, the instructions are not good. They use measurements of mm instead of inches and there are no words whatsoever only pictures. I am very handy have put 3 other barn doors up but this guy gave me a run for my money. The lower pivot has to go into the floor and not the wall or casing like your standard bi fold door. In my case I had to drill through porcelain tile as I used the door in my bathroom. Now that its installed I love it.
Great option, love this hardware.
Easy, great look yet works as a bifold!!! Love it.
Easy to install and very sturdy
I didnt know this sort of barn door hardware existed for bi/fold doors until I happened upon it in . Wed been looking for a modern solution to adding doors to our non/standard closet opening and this worked perfectly. It mounts easily and holds the doors well. Id recommend it for anyone looking to mount bi/fold doors without having a clunky floor track.
Not that easy to install but it works fantastically once you do
A little difficult to install if youre doing it yourself. But once its up it is money.
Add a review