Poor qc, unacceptable solutions to problem while assembling pieces in the factory
Assembling this thing was a chore, none of the bottom holes really lined up with the legs, so it took some doing to get the holes for the screw to line up. If that were the only issue it would not be so bad, but the qc is absolutely garbage. They drilled the hole for the plastic foot pad too deep on the bottom of one of the legs, so they simply stacked 2 plastic foot pads on the bottom of the leg to make up the difference. The table would wobble and there was no way to correct it with the build they had done. I had to use a drill bit for drilling out the latch for a door knob on a piece of 1/4 inch plywood and glue that into the hole, and then nail their plastic foot on, which was bent up and the nail had ripped out. I had to use some wood glue to get that fixed, and the wobble is much better, that said, I do not know how you can drill a hole too deep on a leg and find an acceptable method of fixing it to just stack a bunch of plastic feet on the bottom to make up the difference. For the price they charge for this it is a garbage solution. Fix it in the factory or get a new leg, dont send out
Poor qc, unacceptable solutions to problem while assembling pieces in the factory
Assembling this thing was a chore, none of the bottom holes really lined up with the legs, so it took some doing to get the holes for the screw to line up. If that were the only issue it would not be so bad, but the qc is absolutely garbage. They drilled the hole for the plastic foot pad too deep on the bottom of one of the legs, so they simply stacked 2 plastic foot pads on the bottom of the leg to make up the difference. The table would wobble and there was no way to correct it with the build they had done. I had to use a drill bit for drilling out the latch for a door knob on a piece of 1/4 inch plywood and glue that into the hole, and then nail their plastic foot on, which was bent up and the nail had ripped out. I had to use some wood glue to get that fixed, and the wobble is much better, that said, I do not know how you can drill a hole too deep on a leg and find an acceptable method of fixing it to just stack a bunch of plastic feet on the bottom to make up the difference. For the price they charge for this it is a garbage solution. Fix it in the factory or get a new leg, dont send out